How To Repair Cracked Tail Light Lens

Download Commodity

Download Commodity

Ignoring even a small crack in a taillight lens can cause enough of trouble for you in the hereafter. Besides the obvious trouble of mayhap receiving a ticket for the broken lens, a less obvious problem is water impairment. H2o can creep into the smallest opening, and if left unchecked, it can fog your taillight assembly interior and eventually short the taillight out. Y'all tin repair taillight lenses for much less money than buying a new assembly from the automobile parts shop, and it simply takes minutes to do.

Steps Download Article

1. 1

   Make clean the taillight lens associates thoroughly by spraying cleaner on a rag and wiping down the lens. Exercise not allow any liquid to get within the housing.

2. 2

   Remove the lens from the housing using the appropriate screwdriver. If the lens is glued to the housing, do not endeavour to pry information technology off every bit that will probable break information technology. Instead, remove the unabridged taillight associates and follow these directions to remove the lens from the housing without dissentious it.^[1]

   • Heat a kitchen oven to 200�F (99.3�C), and position oven rack in lowest position.
   • Line a baking sheet large enough to concord the assembly with foil, and identify the associates on the baking sheet with the plastic lens facing up. Place in the oven for 15 to 20 minutes.^[ii]
   • Remove the blistering sheet and assembly using oven mitts and carefully, using a flat edged screwdriver, pry the plastic lens from the housing. Remove the soft strings of glue from the edges of the lens while it is still warm using a abrupt box cutter.

   Advertising

3. 3

   Wipe downward the within of the housing and the lens using a dry fabric.

4. 4

   Sand the edges of the cleft using #200 fine dust sandpaper to give the adhesive a rough surface to cling to. ^[3]

5. 5

   Apply a fine line of plastic glue along the crack, holding the pieces together with your hands for a infinitesimal to let the glue to set up. If necessary, apply a second line of glue when the commencement ane dries. You desire the crack to be totally filled and even with the surface of the lens. If you apply too much gum, sand off the backlog using #200 fine dust sandpaper.^[four]

6. 6

   Employ a line of plastic glue forth the edges of the lens earlier replacing it in the housing and fastening down the screws.

7. 7

   Reattach the assembly to the car if necessary. ^[5]

Advertisement

Add New Question

• Question

  What kind of glue can I apply to embrace the cracks?

  

  Gorilla Glue works best for the cracks. Exist certain to get the clear glue, otherwise y'all will have yellow all over the lens.

Inquire a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Advertisement

• A heavy duty hair dryer might work to loosen the agglutinative on the lens rather than using the oven.

• You tin purchase special adhesive made for gluing plastic lenses at an motorcar parts shop, or you can use the old fashioned glue used for plastic models, usually found behind the counter in hobby shops.

Advertizement

• Make sure the kitchen is well ventilated before placing plastic parts in the oven.

• Practice not utilise a cyanoacrylate based agglutinative to glue plastic taillights, as it will somewhen eat through the plastic.

Advertisement

Things Yous'll Need

• Screwdriver
• Plastic glue
• #200 grit sandpaper
• Oven
• Blistering sail
• Foil
• Oven mitts
• Pilus dryer

Most This Article

Thanks to all authors for creating a folio that has been read 68,070 times.

Did this commodity aid you?

Source: https://www.wikihow.com/Glue-a-Taillight-Lens

Share this post